Clik here to view.
Clik here to view.
Clik here to view.
Clik here to view.
The first real panel - turned out nicely
.:madworm:. has posted:This time it's got it all: a frame, machine-handling and alignment holes and fiducials. Heck, I even added a unique board-identifier (git commit-id-#). I will keep at least one...
View ArticleClik here to view.
Clik here to view.
Another reason to use git for version-control
.:madworm:. has posted:Getting started with git version-control: git-scm.com/book KICad PCB: www.kicad-pcb.org
View ArticleClik here to view.
Clik here to view.
Lighting up
.:madworm:. has posted:I messed up the solder mask a bit. Not too shabby for the first prototype of the 2nd series.May be found on tindie.com
View ArticleClik here to view.
Clik here to view.
Clik here to view.
Clik here to view.
Clik here to view.
Clik here to view.
MBI5030-SB assembly 20
.:madworm:. has posted:Solder all pins. This works quite nicely with a largish tip (hoof, wide chisel...). Thanks to the paste flux you can just wipe it across the pins, adding a bit of solder once in...
View ArticleClik here to view.
Clik here to view.
Clik here to view.
Bottom side done
.:madworm:. has posted:Using those resistor packs was a very wise decision. Assembly time was cut down a lot.
View ArticleClik here to view.
Clik here to view.
Clik here to view.
KiCad - panelized by hand
.:madworm:. has posted:It's doable for small panels, but gets tedious pretty quickly. Creating a footprint for the mouse-bites helped a bit. It would be really nice if KiCad supported "cloned" copies,...
View Article
